Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

CSI Bridge_End Length Offset

Status
Not open for further replies.

yaroosh

Structural
May 11, 2015
32
Hello Everyone, I am using CSI Bridge and I noticed that the program automatically assigns end length offset. Is there away to control it? I know I can manually change it but the issue is when I update the bridge model, it resets itself to what was automatically assigned on the first place. Have anyone experienced the same issue? Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor