curved washer 1

[hotiron]

Hi all
I can wrap geometry onto a curved surface or extrusion. How can I cut and leave the wrapped sketch?

 

[CorBlimeyLimey]

The wrapped sketch isn't actually created when used in a Deboss or Emboss feature. If you want a representation of the wrapped sketch, try using the Scribe option.

If you explain what you are trying to achieve, we may be able to give a better answer.

 

[hotiron]

CBL
I am trying to model basically a curved or bowed washer. (a flat washer formed into an arc to act as a spring) Ive extruded the partial arc and were trying to use warap to get the form I need, but cannot trim sections outside of the form.

 

[CorBlimeyLimey]

Why not create it the way it will be created in real life ... as a Sheet Metal part with a sketched Bend?

 

[hotiron]

CBL
I'll have to play with it as I dont use sheet metal tools much. Ill research what I can and any tips would be great.
Thanks

 

[Eltron]

You can also just do a sketch of the cross-section of the washer and do a revolve. That should get you where you need to go.

Dan

http://www.eltronresearch.com

 

[mappel]

Here is a Single Wave Spring Washer I created.

 

[MadMango]

Here's another curved washer model, with configs for normal and compressed states.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of Eng-Tips Forums?