I need to cut out this section, and I think I need to use revolve cut. Here is a picture. Can someone tell me how to cut out this section along the interior of this wall?
I'm sorry for not giving the info about my Solidworks 2012. I've been rusty. CChunter, thanks for the help. I knew that I was close, in fact, that was a total brain fart. Take care guys.
Yeah, definitely SolidWorks. You can tell by the shadow below the piece.
I would cut the circular channel in first by revolving the cut profile, then add the slots. Easier than how you have it laid out and probably the way the machinist would do it.