Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Daft Question About Parameters

Status
Not open for further replies.
Simes

Simes

Automotive
Feb 13, 2017
7
GB
Hello!
Once I've made a parameter and re-named it, is there any way of viewing the parameter type, or editing the parameter type?
Thanks all
Simon
 
Replies continue below

Recommended for you

Sort by date Sort by votes
don't think you can change the type

Eric N.
indocti discant et ament meminisse periti ​
 
Upvote 0 Downvote
That's annoying. Found out how to check what they are though- just go parameters and filter the view by parameter type.
Thanks for your help
 
Upvote 0 Downvote
@Simes
You can't change the parameter type after creation. It's set in stone. Your best approach would be to create the new parameter of the correct type and use the "Replace" command to swap it in for the previous parameter and have all of the links update.

Drew Mumaw
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Lukasz Iranski
  • Locked
  • Question
CATIA Customize View Parameters MACRO
Replies
2
Views
42
Lukasz Iranski
Lukasz Iranski
eduardopinto07
  • Locked
  • Question
EKL Parameters search and selection.
Replies
9
Views
63
eduardopinto07
eduardopinto07
xPAIVAx
  • Locked
  • Question
Link two parameters CATIA V5
Replies
4
Views
50
xPAIVAx
xPAIVAx
Costin Ruja
  • Locked
  • Question
Discrete list of parameters 1
Replies
3
Views
25
Costin Ruja
Costin Ruja
VN1981
  • Locked
  • Question
Question about modeling practices in GSD
Replies
4
Views
44
VN1981
VN1981

Part and Inventory Search

Sponsor

Back
Top