de Emphasis Blend Color

[uwam2ie]

Since nx 6 the deEmphasisBlendColor is a part setting. Our deEmphasisBlendColor setting in NX3 4 and 5 was gray . We get a lot of parts from coworkers. In nx7.5.3 the color setting on new created parts is working no problem. On migrated parts from nx4 the deEmphasisBlendColor is dark blue on parts from coworkres it is a mixture ... How can I get the same deEmphasisBlendColor on all parts - working in the active part in all assemblys. We (+ coworkers)are using the same cdf file since nx3.
thx in ad /regards

 

[JohnRBaker]

This is all based on the color definition file used by NX. What you need to do is change the .cdf file, replacing the NX 4 .cdf file with the one from NX 3.0. The easiest way to do this is to go to...

Customer Defaults -> Gateway -> Visualization -> Color Palette

...and point the path to the old file and then hit OK and restart NX.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

thx John on reply
the cdf file is constant (the same) used from nx3 to nx75
tia