Dimensioning Problem

[ravindraru]

Hi............
I am having Door panel and want to check its length,width and show it to the customer.
But after checking dimensions in 3d dimensions are like this for Ex:205.02548.I want ---205.02(only two digits after .)
I have searched for this setting in UG,But I failed to get.
If any one know then ...............please reply

Regards,
Ravindra.R.Udandakar
Mob:-+91 9960608414
Design Engineer
International Automotive India Pvt Ltd
Plot no.3 , Rajiv Gandhi Infotech Park,
Phase-1,Hinjewadi
Pune - 411057
rudandakar@iacgroup.com

http://www.IACgroup.com

 

[Arkance/PhoeNX]

Preferences -> User Interface -> Displayed Decimal Places for Dialog Box (see image).


Anthony Galante
Technical Resource Coordinator

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, NX8.0.0.25

 

[JohnRBaker]

Go to...

Preferences - > User Interface...

...and on the 'General' tab, in the first section of the dialog labeled 'Displayed Decimal Places', change the first entry (Dialog Box) from 4 to 2.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[ravindraru]

Thanks John & Antony for your quick reply.......

Regards,
Ravindra.R.Udandakar
Mob:-+91 9960608414
Design Engineer
International Automotive India Pvt Ltd
Plot no.3 , Rajiv Gandhi Infotech Park,
Phase-1,Hinjewadi
Pune - 411057
rudandakar@iacgroup.com

http://www.IACgroup.com