Dimensioning Problem 1

[bastolos]

Is there a way to stop Pro/E from zooming out in sketcher after you modify a dimension? When I'm zoomed in on a dimension and I modify it, Pro/E zooms back out to a full view everytime. Can this be stopped?

Thanks

 

[3dlogix]

Just select to DELAY MODIFY until after all dims's are changed.

Steve

http://www.3dlogix.com

 

[jamesbewley]

You can put this line into your config. I got this on 2001 but it should work on all versions.

sketcher_refit_after_dim_modify

set the value to NO