Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Discard changes and reload from disc 1

Status
Not open for further replies.

DaveJFT

Automotive
Dec 5, 2012
60
Hi Folks,

[V5 R2014]

I'm working in a large assembly and I've made a bunch of changes to a sub-component to test out a theory. The component is used in a number of places in the assembly. The theory didn't work and now I want to discard the changes I made and reload the component from disc. How do I do that without closing and reopening the whole assembly?

Many thanks,

Dave
 
Replies continue below

Recommended for you

Excuses I speak very little English , I use an automatic translator .
For your problem, you must select the top assembly :
rep-comp-00_akvrq5.jpg


Then the screen you tip your play and you select (in french) Edit> Components> Replace Component :

rep-comp-01_bj8ejr.jpg


In the next dialog you select "yes" and you valid OK.

rep-comp-03_smsahd.jpg


Result , the piece has been replaced in all open assemblies in CATIA:

rep-comp-04_y0kyfh.jpg


Hoping to have helped you
 
another way:
1. Close the Assembly window and any other windows of parts you're done with
2. Run the CLEAR HISTORY command (find it in View + Command List)
3. Open the Assembly
 
Hi,

Sorry it's taken me so long to reply - I was dragged off CAD for a few days so did not manage to test out the advice above.

jackk - Thanks for this but it doesn't help as I have actually changed a bunch of components, I'm not ready to save any of them yet and only want to revert one of them. This method just seems to revert the whole assembly which is not surgical enough for my means.

CAD00 - This works when replacing a component with a different component but when I try to do as you describe and revert back to the component stored on disc I get the following:

Operation failed!!
<Path\Partname> cannot be loaded.
A file with the same identification already exists in session.
Remove this file from session to be able to preform operation.


There doesn't seem to be a way to remove a file from session. From my previous experience of alternative CAD packages deactivating a component then allows it to be removed from session using commands similar to Clear History but not in Catia.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor