DMG millturn post-processor

[davidtan20]

I need put [ ] into my postprocessor as notes or a tool list, and I have tried using "new block" and customer commands, I can get (........), but DMG lathe only can reads [........] and customer commands would not let me to use [ ] as text.

guys I need these, and thank you

 

[shags72]

I believe you need to use the escape character in tcl which is \, so \[ whatever \]

 

[joycejo]

In PB on the NC Data Definitions page - other data elements you can specify the Message start end end special characters. Try setting it to text string

John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3

 

[davidtan20]

I have tried the escape character on both customer commands and block before, no luck.

 

[davidtan20]

beauty,it works thank you so much joycejo !!!!