Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drawing Boundary

Status
Not open for further replies.

lostriver21

Mechanical
Mar 30, 2022
1
My CM (configuration manager) is wanting certain markings outside of the drawing boundary (between the edge of the paper and the boarder), is this allowed under ASME Y14.100-2017?
 
Replies continue below

Recommended for you

Where the zone markings go, or further outside that area?
We do put classification stamps outside the border in the zone area, and in some cases remove the zone marking.
On some drawings there is a supplemental drawing number block along the edge of the paper that is outside the border.
We also put the CAD system name that created the drawing under the titleblock outside the border.
I don't see anything in Y14.100-2004 that says you cannot put anything outside the border.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor