I need to find accurate information on the effectivity of the bulbed ends on AND extrusion. The method in Bruhn is to conservative and the analysis sthe bulbs as ineffective. I find it hard to belive they would be there if the didn't help. Does anyone have any info that will help? Nigel Waterhouse n_a_waterhouse@hotmail.com A licensed aircraft mechanic and graduate engineer. Attended university in England and graduated in 1996. Currenty,living in British Columbia,Canada, working as a design engineer responsible for aircraft mods and STC's.

Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Effectivity of Bulbs on AND extrusions

Thread starter Nigel
Start date May 26, 2000

Status: Not open for further replies.

May 26, 2000

Nigel

New member

I need to find accurate information on the effectivity of the bulbed ends on AND extrusion.  The method in Bruhn is to conservative and the analysis sthe bulbs as ineffective.  I find it hard to belive they would be there if the didn't help. Does anyone have any info that will help? Nigel Waterhouse <a href=mailto:n_a_waterhouse@hotmail.com>n_a_waterhouse@hotmail.com</a> <a href= > </a> A licensed aircraft mechanic and graduate engineer. Attended university in England and graduated in 1996. Currenty,living in British Columbia,Canada, working as a design engineer responsible for aircraft mods and STC's.