Error message when using "Wave geometry linker" 1

[Wetblunt]

Hello,

I am using NX 6.0.3.6 and need help figuring out what is the cause to this error. I am trying to link a solid body in a part using "wave geometry linker"
The error message I get says "A deleted or invalid class id was used Unable to create object. Performing an undo."

I started working from an already existing part, so I guess something strange has followed from that part. How can I solve this? Any suggestions?

Regards

 

[uwam2ie]

try a partclean up File ->utilities -> partclean up ( min. 3 times)
or try to replace the wave link feature, create a new wave link -> move this new wave link in the PNT before the error wave link try a replace feature on the error wave link > replace it with the new one.

 

[Wetblunt]

Thank you for the quick reply.

Regarding your second tip: I don't even get a waved link feature. As you can see in my first post, the last sentence in the error message is "performing an undo".
So nothing gets created when I try to link the body. But I will try to do a partclean up and see if it helps.

 

[Wetblunt]

What is it exactly that I should clean up?

 

[Wetblunt]

I tried to clean up both "clean feature data" and "clean interoart links" and it seemed to work

Thank you very much. gonna try to clean only one of the previcious two mentioned and see if it works.

Thanks again