Error type during pipe modeling in Caesar II

[Yoga Arviansyah]

Hello everyone,

I am currently modeling the pipe through the Caesar II application, but there is a problem that I face is about Bend.
The picture can be seen below.

Is there a suggestion to overcome this ??

Thank You

 

[1503-44]

I am guessing here, but it sounds like for some reason the pipes being connected are not aligned correctly to match the bend angle, or the specified angle is off by more than 5°. The bend needs more distance between the pipe end points to fit between the two nodes. ???

A black swan to a turkey is a white swan to the butcher ... and to Boeing.

 

[Yoga Arviansyah]

seems to work, thanks with your answer, have a nice day