Exact Curve error when updating views

[Suskam]

Anybody run across this error in NX10? When updating views in drafting: "Exact Curve could not be created. This was caused while updating an object of type in part (XXXXXXX.prt)" I can't find a solution except to delete the view and re-create it. Very frustrating if the view has a lot of notes and dimensions. Is it a bug or something I am doing?

Product Designer: I-Deas/NX/Catia
Automotive Industry

 

[Suskam]

The silence is deafening.

Product Designer: I-Deas/NX/Catia
Automotive Industry

 

[cowski]

I've not seen this particular error (but then again, I'm still running NX 9). These types of errors are best handled by contacting GTAC; they have better means of diagnosing the problem.

That said, I have seen similar errors in drafting, usually when updating a section view, that was caused by model geometry errors. Try running "examine geometry" on your model to see if anything comes up.

www.nxjournaling.com