Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Exporting images out of Teamcenter

Status
Not open for further replies.

Nolemite

Mechanical
Feb 25, 2009
3
I would like to export a part print out of Teamcenter. I have had success doing this using the 2D exchange feature most of the time. I recently ran into a part that appears to be a jpeg or tiff inserted into the titleblock. It does not show up when I export using 2d exchange. When I try to plot it or export to pdf it is too hard to read. What's the best way to export it?
 
Replies continue below

Recommended for you

exporting to PDF seemed to work best. I didn't realize I could export a PDF out of Teamcenter.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor