Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FEA for crack

Status
Not open for further replies.

phasedarray2

Petroleum
Feb 20, 2009
2
IR
Dear All.

1.Can anybody introduce some guide book or learning material about design of pressure vessels by ASME DIV II PART 5& which software recommended for this purpose?
2.is there a comparative table that shows advantage and limitations of FEA software for crack and fatigue in metalls?

Regards.
 
Replies continue below

Recommended for you

Hi Daniel.
Thank you for sharing but in this book a little spoken about design by analysis.
Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top