Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Feature updates in NX-6
- Thread starter HerbC
- Start date
JohnRBaker
Mechanical
I think you will have to be a little more explicit in describing what it is that you're doing when you see these 'updates'. Can you provide a sample part and a step-by-step description of what you did? Or, since in NX 6.0 we can now do video captures of what you're doing on the screen, why not record and post a short clip as they might also help to show what's happening and what it is that you might be doing which is causing it?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
JohnRBaker
Mechanical
The use of Mold Wizard would probably explain that behavior and therefore should not be used a general example of NX performance or behavior.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #5
JohnRBaker
Mechanical
I was simply stating that the performance of Mold Wizard is not indicative of the general performance of NX.
You state that you are "using the pocket design function FROM the Mold Wizard package". Are you actually using the complete Mold Wizard product or just one of this functions? If so, why are using that instead of taking a more conventional approach using normal NX Modeling functions?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
You state that you are "using the pocket design function FROM the Mold Wizard package". Are you actually using the complete Mold Wizard product or just one of this functions? If so, why are using that instead of taking a more conventional approach using normal NX Modeling functions?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Status
