MIANCH
Chemical
- Aug 8, 2002
- 162
Dear alls,
I face problem while running pipesim model for field development case. I connected 11 wells and one separator and three sinks. I specify the Pressure, flow rates and temperature. first thing model give warning that PQ required lesser. I tried and remove some of them and model became active and converged but results are not good. second time I remove all flows and keep pressure and temperature conditions and model converged.
My question is, if no flow conditions provided and pipesim calculate by himself then accuracy is questionable. can anyone explain how to solve this problem.
Thanks
I face problem while running pipesim model for field development case. I connected 11 wells and one separator and three sinks. I specify the Pressure, flow rates and temperature. first thing model give warning that PQ required lesser. I tried and remove some of them and model became active and converged but results are not good. second time I remove all flows and keep pressure and temperature conditions and model converged.
My question is, if no flow conditions provided and pipesim calculate by himself then accuracy is questionable. can anyone explain how to solve this problem.
Thanks