g codes 1

[simon3015]

Hi does anyone know if there is a g code to make a amada 3015 fo laser change shuttle beds and re-start the programme automatically .I get a lot of long running sheets that ill like to run during the knight with minimal supervision .

 

[LaserEngine]

Hi,

What shuttle table do you have? And are you using Dr.Abe for nesting?

 

[simon3015]

It's a amada 2 bed shuttle and yes I am using Dr abe

 

[LASERNINJA]

G130 at the end of the program, in place of g50.

M707 to shuttle, M97 repeats the same program on table #2.

There are ways to run a different program on table #2 but it's a little complicated if you have an NT machine.

 

[simon3015]

Thank you I will try this tomorrow it's a fo laser if that makes a difference I really appreciate all the help I get with streamlining our process new ventures are more successful with the help of wiser ones