I still cant figure it out. So far, i have created the revolve feature (solid) only. How do i go about finishing the rest? i was thinking of a sweep feature but nah, what about a blend feature, problem is that radius is not actually a blend. It's located 0.156" away the rear face..
Steve mentioned merging the revolve features. So you meant to create one revolve for those 4 indents. Then use the merge feature
Probably a hundred ways to do this part. The detail of the indent is a bit hard to make out on the sketch but a simple way would be:
1> create the cylinder as a surface with capped ends.
2> trim the top open
3> sketch a sweep path for the indent
4> sweep a surface profile of the indent along the sweep path
5> pattern on axis 4@360
6> merge
7> add rounds
8> thicken
done.