Graphics card size 2

[sudhakarn]

Hi folks,
How do I check that I have the required graphics for my CAD Application.Suppose the application demands 1 GB of graphics.The adapter properties shows total available graphics memory as 1664 Mb and total video memory as 32 MB.

How do I validate my requirements?Request your support pls.

 

[sudhakarn]

Hi folks,
Any updates on this?Awaiting your reply.

 

[jzecha]

What is your CAD Application?

Catia can run on just about any Graphics Card, it is just up to you on how well you want it to run.

 

[ferdo]

For CATIA you have here everything you wish.

Regards
Fernando

https://www.youtube.com/playlist?list=PL9mSHa4SOedV3dr0D3kfIWFUg7mIYm94k

 

[kayla_engineer]

Here's what Creo's Simulation Live Requires as far as cards go.
The only other recommendation with them is that you have a minimum of 4GB RAM (8GB recommended)

 

[sudhakarn]

Thank you folks.Will check them out.

 

[sudhakarn]

Hi folks,
I just need a clarity here.If the application demands 1 GB of graphics RAM ,then should I consider the total graphics memory or the video Memory?

 

[kayla_engineer]

@sudhakarn

I would think it would be graphics RAM unless you're doing video/animation processing in which you might want to go with a card that sums both GB values.

I know in Creo Simulation Live, they say that you need the following specs:
- Dedicated NVIDIA CUDA graphics card
- Minimum 4GB video RAM with 8GB video RAM recommended on the GPU (graphics processing unit)
They specify on the video memory.

Just my opinion. Hope this helps.

 

[Ricardo S. Lancaster]

You should consider the total graphic memory/ In your case your graphic cards is fine for your needs