Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hebrew Font Notes in NX7.5

Thread starter aeroseat
Start date Aug 15, 2012

Status: Not open for further replies.

Aug 15, 2012

aeroseat

Mechanical

I'm having some trouble getting a Hebrew note to display correctly. I've added Hebrew_Multimode.fnx from another post to my ugfonts directory and chosen it as the style (also tried Arial, etc). I'm using NX 7.5.5.4. Hebrew shows fine in the Edit Text box, but only shows as squares (and a comma) in the part. English text is working fine. Basically, I copy the Hebrew translations from my customer and need to paste it on my placard. Insert>curve>text works but then it's difficult to make changes. Any suggestions that would allow later editing?
Thanks,
Aeroseat