Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hello, I have to provide anchor bo

Status
Not open for further replies.

Engr ZANIA

Civil/Environmental
Feb 19, 2018
34
Hello,
I have to provide anchor bolt in block foundation for dynamic equipment, i cannot provide clear concrete cover around the bolt more than 19mm, as there's an another block adjacent foundation. Please suggest is that possible?? As pryout strength may be control by adjacent existing foundation. calculation based on edge distance is safe for all load cases
 
Replies continue below

Recommended for you

provide a sketch with loads, edge distances, general geometry.

But based off what I can figure out from your description, you've only got 19mm from edge of bolt to edge of concrete. There's no way that will work.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor