Hello,

[drasticxxx]

IS IT POSSIBLE TO DEFINE SET NODE ON A MESH AFTER SUBMITTING THE JOB
i KNOW THAT THERE ARE ONE IN THE ASSEMNLY,BUT I NEED TO DEFINE ON IN THE MESH

please HELP

 

[IceBreakerSours]

You can define a node set both in the part and the assembly (and subsequent) modules. But you can not define a node set "after submitting the job".

By the way, turn your caps off.

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[drasticxxx]

sorry for that,and i appreciate your help,
I asked this question because, i need to calculate the Force displacement curve,and i need to calculate the average force and the average displacement for every point on the curve , and by repeating this process i can draw the curve,

So what I am try to say that this process is very difficult

Is it possible to do this in much easier way.

I dont want to pick the same points as many time as the increment of the step, to draw the curve,,Please help me

 

[Simon012]

Please Read this post. It might be helpful for you.

http://www.eng-tips.com/viewthread.cfm?qid=347232