Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help, Domestic water booster pump system 1

Status
Not open for further replies.

dchesky

Specifier/Regulator
Feb 2, 2004
2
34 story residential pump package contains 3 goulds 3-stage 20HP pumps, cla-vals, etc. The stainless steel impellers disintegrated 3 months after install. Could be debris in water? or something else... Not cavitation as the suction pressure is constant and controls would shut pumps down if flow was reduced. Any ideas??
 
Replies continue below

Recommended for you

Was the system cleaned with TSP and not flushed properly?
 
SS also doesn't like the following
Sodium Hydroxide
Sodium Hypochlorite
Sodium Biscarbonate
Sodium Bisulphate
Sodium Bisulphite
Sodium Borate
Sodium Bromide
Sodium Chlorate
Sodium Fluoride so if any thing here was used as a cleaning solution and wasn't throughly flushed it could be your problem ..ck the chemistry of the water.
 
Since this is domestic water (drinking and bathing, etc.) i would think that people would have complained about water quality. How much of the substances you mentioned is needed to affect the SS. If so, wouldn't it be washed away into the system and out through sinks, tubs, toilets, etc.??

Thank you so much for your input!
 
dchesky
A place to start..
Heat...
Mechanical contact with something....
Chemical (as Imok commented)........
Manufacturing flaws (loose impellors,
housing imperfections)
Improper installation.....
Coupling misalignment.....


Did the impellers appear to have
been chemically, mechanically or
thermodynamically damaged ?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor