Help modelin opening mode models are distorted

[ARPERO]

Hello good morning
This problem was presented aráis you change cpu
I have two licenses for both nx7 NX3 to both do the same
Drafting And when I go to distort the dimensions of value and instead appear only a symbol.
That is:
I would like to help me

 

[ARPERO]

Also attached a file with the image errors

 

[JohnRBaker]

OK, try this.

Open the part file in NX 7.0, go to...

View -> Camera...

...and in the section of the dialog labeled 'Clipping', select the 'Fit Planes to Extents' button, hit OK and see if this helps.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[hudson888]

I don't follow exactly but the images tell a story. What you have there is a graphics card problem. Whether it is drivers or the hardware itself I couldn't say, but I would try upgrading the drivers if possible to see if there is any improvement. Otherwise what sort of machine and graphics card do you use?

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum