Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help with balloon stacking?

Status
Not open for further replies.

RailSnail

Industrial
Jan 8, 2020
7
Using NX12 here. Balloons are not stacking. I have checked all preference setting without success. Restarting NX does not resolve the issue either, Anyone have any insight on such an anomaly?

Curtis
 
Replies continue below

Recommended for you

I do not get any error. The second balloon just floats over the first. It wont do a snap/drag horizontal align either. Stack in Preferences is enabled. I do not get a STACK HORIZONTALLY or STACK VERTICALLY either when I select a group of them and right click (per cowski's link.) It is NX12. Snap of settings below- hope it comes thru.

Balloons_asxr0n.jpg
 
Have you tried alignment options other than "top left"? While on the GTAC site, I ran across an article that indicated the "top" alignment didn't work well; but that was for an older version (NX 7.5, I think). Still worth a try - sometimes bugs get carried over for years...

www.nxjournaling.com
 
This is the strangest thing everyone. I messed with this yesterday afternoon and this morning. Rechecked settings again. They still wouldn't work. I no more than turned to talk to a coworker and mentioned they wouldn't stack. Went to show him and they stacked. I am still in the same NX session as yesterday. Truly baffling. Thanks for your replies.
 
I've found that when 2 or more people look at a computer problem, it tends to scare the gremlin away.

Glad to hear that you are back on track.

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor