Hole Table - Difficulty selecting holes with breakline present

[Kuli24]

Hey.
When I create a hole table (by hole size) on a drawing view that contains a breakline, I am unable to select the holes that aren't visible due to being in the breakline zone. If I uncheck "show broken view", I can get the hole captions placed and the hole count correct in the table, BUT
when I check "show broken view" again, the hole captions stay as they were if the view was unbroken.
I'm just trying to get an accurate hole count with a broken view.

Thanks.

 

[Kuli24]

I've attached a picture to better illustrate my problem.