Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I create a hinge commector in abaqus using hyperemesh as the pre processor.

Status
Not open for further replies.

SATISH KUMAR

Mechanical
Nov 16, 2017
1
Hi,

I am a beginner in abaqusa and I am using hypermesh as the pre processor. I am into connector problems where I need to define a hinge commector between two components. But, I could find the procedure to do so..

Can anyone with expertise in this help with this..??

Thank you..
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor