How to enable Hybrid Manufacturing & Additive tab, File>New

[AmMach]

Hello Everyone.

Quick Q, i got NX11 and am struggling to update the templates in FILE>New TO enable the Hybrid manufacturing module and additive tab.
Its been 5 years since i last did (was working with other software all this time) and thus i dont want to mess up everything in UGII.


Thanks a lot for your time and help.

A

 

[cowski]

Hybrid manufacturing/additive is relatively new to NX; I doubt that NX 11 supports it.
However, if you want to add tabs to the "file -> new" menu, it is usually done by editing/adding pax files.

www.nxjournaling.com

 

[AmMach]

Thanks a lot Cowski.
i have done it in the past with NX10(it was available since then), yes, problem is its been a long long time and am not sure which paxfile to edit

 

[cowski]

Copy one of the default pax files and edit it for your needs.

www.nxjournaling.com