How to identify Basic Curves using NXOpen?

[koutilya]

Hi all,

is there any way to identify Basic Curves using NXOpen? Any help in this regard is greatly appreciated..

Regards,
Koutilya

 

[JohnRBaker]

What exactly do you mean by 'Basic Curves'? As opposed to what...?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[koutilya]

Hi John,

Thanks for your quick reply. Basic curves means those lines & arcs which won't list in the feature browser dialog. I am attaching the image for your better understanding.

 

[JohnRBaker]

I suppose you could check to see if the curve was a member of a feature and if it's not then it's a basic curve. But I don't think there's anything like a 'filter' which will block one type of curve (feature or basic) from another.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.