How to make Compound Frame GD&T in NX11

[Jashe]

I am trying to make a compound tolerance frame in NX11 but when I use the GDT tool that's available there's a space between the two frames. Recently I've been using the Text tool for a single frame with text under it. My question is, is there a way to create a compound tolerance frame using the text tool to eliminate the space in between frames? I've attached a power-point illustrating further details.

 

[apekas]

this is the code you need to use

<&70><+><&10><+><O>3.0<M><+>A<+>B<M><+>C<M><+><&80><+><&8><+><O>0.5<M><+>G<+><&90>

 

[Jashe]

Thank you very much. <&80> is the connector between the two frames. I knew I was close.

 

[NutAce]

If I'm correct, you can also create 2 separate ones using the GDT tool.
If you create the second one and move it onto the first they should snap together.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11