How to rework curve continuity

[uwam2ie]

see what I can learn...
I have parametric curve with multiple segments (from a projection), see attached jpg. What is way to rework the tangengency problem between this to segments without removing the parameters?
thanks/regards

 

[JohnRBaker]

What version of NX are you running?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

Nx7.5
thx

 

[uwam2ie]

Hey JOHN; any suggestions?
reg.

 

[cowski]

Is this the result of 1 projected curve feature (2 curves/edges selected to project)? If so, have you tried out the join curve option (located in the "settings" section of the dialog box)?

 

[uwam2ie]

thx cowski on reply,
my question is more how to handle the problem direct without losing the dependcy - not the workoround

 

[JohnRBaker]

If the imported curves are not continuous, there is nothing that can be done without taking some extra steps, such as joining them or modifying one curve so that it matches the other, but these require explicit actions on the part of the user.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.