jerry1423
Mechanical
- Aug 19, 2005
- 3,428
I am still a rookie at mechanical routing, but I am learning more each day.
I would like to create my hydraulic hoses as straight, then form them in the machine assembly, because some of the hoses will be used in more than one machine location.
It is my understanding that it is possible to add spline points to the formed hose in the assembly, but I can't find anything like that.
Is it possible to add spline points to the spline of a hydraulic hose that is formed in the assembly ?
I am on NX1899.
Jerry J.
UGV5-NX1899
I would like to create my hydraulic hoses as straight, then form them in the machine assembly, because some of the hoses will be used in more than one machine location.
It is my understanding that it is possible to add spline points to the formed hose in the assembly, but I can't find anything like that.
Is it possible to add spline points to the spline of a hydraulic hose that is formed in the assembly ?
I am on NX1899.
Jerry J.
UGV5-NX1899