HydroCAD - Weir Model

[SimonLuc]

Hello,
I’m reaching out to see if you can help me with modelling an outlet device based on the information provided in the attached PDF. I can’t figure out how to create the weirs (boxed in red), but I managed to model everything else. Unfortunately, I do not have additional information for the weir and do not know the type (sharp-crested, broad-crested, etc.). Is it possible to model this based on what I have?

 

[psmart]

Your PDF shows how you have modeled the weirs in HydroCAD, but it doesn't give me any idea of what you're actually trying to model. Do you have a sketch of the weir?



Peter Smart
HydroCAD Software

http://www.hydrocad.net

 

[SimonLuc]

Hi Peter,
Sorry, I should've clarified this. I'm trying to recreate the HydroCAD model based on the attached PDF. I don't have other information to work with besides the HydroCAD reports and I don't have a sketch of the weir. Also, I was not provided a contact to the original person that created the PDF which is why I'm struggling to piece this model together.

 

[psmart]

Since you have the HydroCAD report, you can create the outlet devices exactly as shown. Devices 3 and 4 appear to have been created with the Orifice/Grate outlet device.

Peter Smart
HydroCAD Software

http://www.hydrocad.net

 

[SimonLuc]

Hi Peter,
I've got it all modelled now. Thanks!