identification of blank part in an assembly

[sachinTata]

i want to identify blank part in an assembly through macro.

what i am doing now is checking hidden state of partbody, body and geometrical set.
as well as searching geometry in the body, partbody and geometrical set ( if they are in unhide mode).


Is there is any other way to check this...

 

[itsmyjob]

well this is up to your definition of blank

Eric N.
indocti discant et ament meminisse periti ​

 

[sachinTata]

hey itsmyjob, as per the requirement blank part means part without geometry or if geometry present then it must be in hidden mode.
for eg, check below two file

 

[itsmyjob]

don't forget deactivated geometry:

if all features are deactivated then volume = 0

Eric N.
indocti discant et ament meminisse periti ​