Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Identify boundary edges and silhouette curves in a drafting view using NXOpen ?

Thread starter biw01
Start date Jun 6, 2017

Status: Not open for further replies.

Jun 6, 2017

biw01

Automotive

Hello Everyone,

I wanted to know if there is a way to identify boundary edges and curves in a drawing view using NXOpen (NX9). I am struggling to identify the outline of the drawing.
Any help in this regard will be deeply appreciated.

Thank You,
Amitabh