In NX7.5 specify segments for approximation is missing?

[mgmug]

NX6 can smooth a spline approximation for defining a number of segments.
In NX7.5 is no longer possible?
I thank those who can give me suggestions.
Ciao.

 

[JohnRBaker]

Have you looked at...

Edit -> Curve -> Smooth Spline...

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[mgmug]

Yes I have seen
nx7.5 missing in the approximation for the number of segments

 

[mgmug]

I attach image

 

[cowski]

Perhaps you are looking for Insert -> Curve -> Fit Spline...? Make sure you are running with full menus.

 

[mgmug]

In NX6 was:

Edit->Curve->Parameters->OK
then
->Smooth
then
->Segment
then
->Approximate

In NX7.5 is no longer possible.

 

[cowski]

If you create the spline as associative (there is an option in the studio spline dialog box) you cannot edit the spline in that way. If the spline is unassociative it works the same way.

This behavior is the same as in NX6.

 

[mgmug]

Not quite what I was looking for but this method is however a workaround.
Thanks for the suggestions.
Ciao.