Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

increase dielectric strength

Status
Not open for further replies.
ebirinci

ebirinci

Electrical
Dec 14, 2015
11
does anybody know how to increase dielectric strength in rubber compounds
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I don't.
Mike, how is it done?

Gunnar Englund
--------------------------------------
Half full - Half empty? I don't mind. It's what in it that counts.
 
Upvote 0 Downvote
Mike, how is it done?
I read oil, sulfur increase dielectric strength in cured EPDM.
 
Upvote 0 Downvote
What type of rubber compound and what level of dielectric strength is desired (volts/mil)?
 
Upvote 0 Downvote
EPDM insulation jacket. desired is 2000 volts/mil
 
Upvote 0 Downvote
Increased oil and sulfur levels may not quite get you there, 2000 volts/mil is higher than normal EPDM dielectric strength.
You may consider reducing or eliminating carbon black content as this helps. Also there has been some success in "doping" or
filling EPDM with silicone like materials.

Is this something you are trying to spec out as a premade cable jacket or a jacket material that you will apply over a group of
wires/conductors?
 
Upvote 0 Downvote
I didn't say that _I_ knew.
I just answered the question as asked.
... and sure enough, someone showed up.


Mike Halloran
Pembroke Pines, FL, USA
 
Upvote 0 Downvote
"Is there a doctor in the audience?"

Gunnar Englund
--------------------------------------
Half full - Half empty? I don't mind. It's what in it that counts.
 
Upvote 0 Downvote
thank you jimhan. Yes this is for cable jacket. I don't use carbon black but I'll try silicon like material.
 
Upvote 0 Downvote
how about mica? Mica has the highest dielectric strength.
 
Upvote 0 Downvote
Mylar is an interesting thought. I'm not sure how that could be incorporated into the EPDM material but I'd like to know.
 
Upvote 0 Downvote
mylar is a film. How is it going to be mixed in with EPDM. I'll try mica as a powder
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

pmgohpelangi
  • Locked
  • Question
dc dielectric test for 33kv cable 1
Replies
8
Views
113
7anoter4
7anoter4
ziggy-zag
  • Locked
  • Question
Voltage Drop Increase on a Minimum Neutral for a 3W Service?
Replies
1
Views
54
waross
waross
adi 3291
  • Locked
  • Question
Calculating additional Increase in Current due to Harmonics in the capacitor bank 2
2
Replies
37
Views
265
adi 3291
adi 3291
BigJohn1
  • Locked
  • Question
Does grounding a wye increase inrush? 1
Replies
15
Views
38
BigJohn1
BigJohn1
SA07
  • Locked
  • Question
How to increase lifetime of ceramic isolators on 66 kV line? 4
Replies
4
Views
27
bacon4life
bacon4life

Part and Inventory Search

Sponsor

Back
Top Bottom