Inferred Constraints - level of application ?

[daluigi]

Are those Inferred Constraints Settings applied for the current sketch or valied for the all session instead ?

 

[JohnRBaker]

Any changes made to the 'Inferred Constraints and Dimensions' setting during the creation/edit of a sketch will remain in effect for the entire session, even if you open a new part and create/edit a sketch in that part. However, upon leaving NX and restarting a new session, the settings will go back thier defaults.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.