We are using the grid design to create aircraft composite panels. We have acquired the weight from Numeric Analysis; however, when we use 'Persistent' we only see the Analysis for the individual plies within the tree; don't see a total anywhere for the panel. Does anyone know a way to get the Composites Numeric Analysis to capture the Total mass/weight, that is in the Analysis window,in the Tree?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Is there a way to get the Composites Numeric Analysis to put the Total mass/weight in the Tree
- Thread starter l3obAero
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question