Issues changing the solid tree

[robcp]

Hello,
I am trying to change the trim line of a stamping component. I order to make the change; I have to create a pocket. I would like the pocket to be created inside of the "assembly" boolen operation, under a body, to be able to mirror the pocket later. When I try to create the sketch for the pocket, ones each line or curve is created suddenly disappears and I cannot see the last feature created, but the sketch is shown in the solid tree as something that has been already created.
Would you please, let me know how I can make the sketch visible to be able to constrain it and do the change.
Thank you.

Rob

 

[5050t]

Make sure your active Body for the sketch is visible - NOT in NOSHOW.

 

[robcp]

The body is visible.

 

[5050t]

Are you able to post a screen capture while in the sketcher WB? Include the spec tree (extended) and all sketcher icons.

 

[robcp]

No, I am not.

 

[DBezaire]

Could you exit Catia and start over. If you have your session on for a few hours it starts to act odd, even with the "Dassault Approved Hardware"

 

[jackk]

here's something else to try:

TOOLS + OPTIONS + INFRASTRUCTURE + PART INFRASTRUCTURE

in the DISPLAY tab:

turn OFF "Only the Current Operated Solid"
turn OFF "Only Current Body"

and just for fun,

turn ON "Geometry Located After The Current Feature"