Join Curve?

[ewh]

Here's another legacy command that I have use for but can't find. Does anyone here know where it went?
NX7

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[jerry1423]

You probably want to use "command finder" to locate it.
Help > Command Finder > enter "join curves"

It looks like it is still there, but it doesn't say where it is.
I am on NX6

 

[JohnRBaker]

Check you Role to make sure that you're using one with 'full menus'

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[ewh]

Advanced with full menus...
Don't know where it came from, but it is now on my toolbar after I did a search for it as recommended by jerry1243.
If it weren't on a toolbar, or if I didn't want it there, how would I find it in the menus?
Thanks!

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[JohnRBaker]

If it were NOT on a toolbar, the 'Find Command' would have shown you where it was located in the menus. The assumption is that when using the 'Find Command' that if it's on a toolbar, show that by default, but if it's not, show me the menu location instead.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[jerry1423]

"How would you find it in the menus?"
The command finder usually points you to its location in the pull-down menus.

 

[ewh]

OK, thanks!

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[jerry1423]

one more thing ...
"Command Finder" is on my "Standard" toolbar (the one with the "start" pull-down). You may want to add it to yours if it is not there. It is very handy, and will save you some headaches finding the commands.

 

[ewh]

Thanks!
It could be worse!
It could be Catia! ;-)

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[JohnRBaker]

I've gone you one better, since the 'q' was not being used as a 'hot-key', I customized my UI so that hitting the 'q' brought up the 'Command Finder' (I chose that letter as it was easy to find on the keyboard).

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.