jeffyoung90
Mechanical
I lofted two cones using the same circle at one end and two different points at the other. I need to merge the bottom portion and remove the overlapping faces, is there a way to do this?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
joining two lofts
- Thread starter jeffyoung90
- Start date
- Status
CorBlimeyLimey
Mechanical
If you have created a multi-body part (i.e. the lofts are not merged with anything else) the Combine tool should be suitable.
- Thread starter
- #3
jeffyoung90
Mechanical
Solidworks doesn't seem to recognize the lofts as bodies, just surfaces. Is there any way to combine surfaces?
CorBlimeyLimey
Mechanical
<sigh> When describing a problem it is usually helpful to relay ALL the relevant details. Solids & Surfaces use different tools. Try the Trim tool in the Surfaces toolbar.
If that's not what you need, and to prevent this turning into a "20 Questions" game, please upload the file or at least an image showing what you want to do.
If that's not what you need, and to prevent this turning into a "20 Questions" game, please upload the file or at least an image showing what you want to do.
- Thread starter
- #5
jeffyoung90
Mechanical
Trim did the trick. Thank you and sorry for the confusion/lack of detail.
- Status
