Journal to select dimension, label, note, symbol and move to a layer(255) and generate PDF on TC.

[Bruno Silva]

Hi everyone,

I would like to know if there's a way on 2D drawing at NX to select dimension, label, note, symbol of each page of a drawing, move to layer 255, save work part only and generate PDF on Teamcenter.

I was thinking in some ways to do that but I cannot make this work.

Thanks in advance!

Bruno

 

[jerry1423]

after you set that filter to what you have press OK then on the menu there is a SELECT ALL button then press OK again.

Jerry J.
UGV5-NX1961

 

[Bruno Silva]

Hi Jerry,

I forgot to mention this step, actually I use select all, but there's a way to select on all pages of a drawing at same time?
Using as I mentioned I need to enter in each page to select all.

Thanks!

 

[jerry1423]

I do not think there is a way to select all pages of the drawing at the same time, but I could be wrong.

Jerry J.
UGV5-NX1961