limited replacement of surfaces in NX10

[longroadtrip]

I have a surface model based on offsets of a base surface. As the design has evolved i need some of the offsets to be run off of an additional base surface.

Is there a way to replace the original base surface with the new one but only effecting a select few of driven surfaces leaving some of the offsets still driven by the original surface.

i have delved into the replace command, but this seems to expect you to be replacing for everything.

thanks for the help

Rob

 

[jerry1423]

You can simply edit the Offset command by pressing [Shift} while selecting the original surface (to deselect it from the command) and then select the new surface after that.

 

[JohnRBaker]

And keeping in mind that the "new surface" being selected MUST have a creation 'timestamp' PRIOR to the creation 'timestamp' of the Offset feature being edited.

John R. Baker, P.E.
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:

The secret of life is not finding someone to live with
It's finding someone you can't live without