Limits a Fits 1

[dzupfrg]

Where is small letters - tolerance (Limits a Fits options) in cylindrical dimensions?
NX9 and NX10.

NX 8.5.3.3

 

[JohnRBaker]

When creating a Cylindrical dimension, whether you get an uppercase letter tolerance for a hole or a lowercase letter tolerance for a shaft, depends on the 'Type' option in the Settings dialog, as shown below (and in the attached image):

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[dzupfrg]

Ok, thanks.

NX 9.0.3.3

 

[dzupfrg]

I noticed that the dialogue "Upper an Lower tolerance" does not update afert change type to schaft - value is not changed.

NX 9.0.3.3

 

[MattBaumann]

Why isn't the "type" option available in the dimension dialog box? This would make it so much easier to switch back and forth.
Also, is there a way to change how the tolerance is displayed? It is currently 10H7(0.015/0) where the H7 is always first. Is there a way to change it to put the H7 after the tolerance in parentheses? It currently doesn't match our long standing drafting standards.