Lofted Cut Leaves Lines 1

[Onionterror]

Please look at image attached.

I used lofted cut (please suggest better ways of doing that) to cut off the revolve where I needed. That was fine. However, the lofted cut left lines which interfere and prevent bulk filleting the 3mm.

How could I do this so I don't create these lines?

Thanks

 

[EngineerErrant]

It looks like the faces are coincident; could you use a reference plane & extruded cut through just those bodies?

"Engineers like to solve problems. If there are no problems handily available, they will create their own problems." -Scott Adams

 

[Jwouters]

Guessing you made the circular bodies with a revolve, can't you just use an revolve angle which would suit your needs?

 

[Eltron]

Can you merge the faces?

Dan

http://www.eltronresearch.com

Dan's Blog

 

[Onionterror]

Thanks.

I actually wasn't putting much thought into it! I've never used the revolve angle before. Revolved it round to where I wanted it and chopped off the triangular prisms at the top.