Thanks for the tip, but honeycomb is no good. I'm infusing a sandwich structure via VARTM. I've never done this with honeycomb, but the weight and cost of all the resin that would fill the honeycomb cells would be terrible for this application.
We're using an impermeable foam core and putting holes in it in order to get resin to the tool side. I did find one company that does it (Dyabgroup) but they have an 11 week lead time. Let me kno wif anyone else knows of one.
Barry1492 (Mechanical)
Have you thought about putting your own holes in.
It is quite easy to take a large block studded with nails and push the nails through the foam at regular intervals.
I know this is a PTA but it can get you off the hook until your supplier can come across.
B.E.
Honeycomb can be used with VARTM. It was used on the Comanche helicopter. But a simpler solution would be to infuse from the edge and fill top and bottom sides of the part at the same time unless you are tying the used the resin to control sheer. If so you should look at K-cor® from Aztex.
We used to have a curved piece about 48" radius and 12" long made with staves and nails pounded from the back with a handle. All you need to do was rock it on the sheet. It is a little irregular but was great for all the VARTM we did in the 80's.
If you want consistency you probably need to make an iron maiden and hit it all at once! Get a tetnaus shot LOL.
Holes in foam are not required. I do VARTM with Rohacell (Close Cell Foam WF) using large structures all the time with success. If interested drop a line
I don't know if Barry ever found something suitable, but i would suggest you consider Tycor from a company called Webcore. They specialize in VARTM-able core/web construction. This might be easier than trying to invent something else. Also I think Vermont Composites was showing something VARTM over core at the 2005 SAMPE show in Long Beach (CA)
Wow....you guys are still responding. Thanks. No, we needed holes to get access to the tool side of th epart since we were infusing from the middle and not the ends.
I found a company in NJ called mahogany that sold some decent stuff. The funny thing is the project is now dead (which I knew it would be) and I got a new job since then. Frankly, I've NEVER liked composites and am glad to be out of the field (no offense guys). It's too itchy, smelly, and such a pain in the ass to work with from both a design perspective and a hands on perspective.