Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Making a simple generator

Status
Not open for further replies.

joeywpittman

Mechanical
May 31, 2004
23
0
0
US
question???
i have a 1075rpm 240v 2hp electic motor. If I connect it's shaft to a 10hp gas engine. Will it product 240volts while the gas engine is spinning at 1075rpms??
 
Replies continue below

Recommended for you

No. Induction motors will not generate on their own.

If the terminals are connected to a 240V line, then it can generate power back into the line as an induction generator. The engine would need to turn slighly above synchronous speed for that to happen.
 
Status
Not open for further replies.
Back
Top